The new DigiSpeed-DC-03 V3 generates an isolated interface for control of CNC equipment that requires an analog control voltage input;
The board can generate the isolated analog voltage from the following sources.
- 0-5V Analog voltage signal as supplied by the Gecko G-Rex G100
- Pulse With Modulation (PWM) signal as supplied by Mach2/3.
- On-board Multi-turn Trimpot for output voltage scaling.
The DigiSpeed-DC-03 requires a regulated 5Vdc supply for operation. It is a perfect fit for your Gecko G100, Smoothstepper or parallel port CNC controller.
It is suitable for use with VFDs such as the Automation Direct GS2 series, as well as other controllers requiring a 0-10Vdc, 0-5Vdc or any voltage up to a 15Vdc control voltage. The DigiSpeed-DC-03 provides the following features:
- Linear DC voltage output (0 -100% of isolated voltage source).
- Max voltage output of 15Vdc
- Multi-turn trim pot for scaling output voltage
- LED Indicator for input signal activity.
- Mode selection via pluggable jumpers. (Included)
- 4mm Mounting Holes
- Optional onboard 5V to 15V DC isolated voltage generator.
- 2 x Signal switching relays with led indicators.
- 3.5mm pluggable connectors for easy maintenance.
- 4 x 10mm plastic mounting standoffs for easy installation (Included).
Note: The DC/DC converter allows you to get a full 10Vdc control voltage output. If you use the 10V supply from a VFD type motor controller, the output from the Digispeed will only be around 9.5V. This is due to the voltage overhead required by the circuitry.